TBS Tango 2 - The 500mW Mod Tutorial

9,431 Views · Posted 4 years ago
It's here! Team Blacksheep just released one of their best products yet: The Tango2 Remote!
It is an all-in-one solution remote&crossfire link, running on OpenTX(freedom tx right now but would be merged into OpenTX soon).
The crossfire RF inside the remote has 250mW output power from the factory but I managed to modify it so that it can output 500mW.

Please support me by subscribing to my channel and pressing the notification bell.

WARNING!
This mod will void your warranty, so you have been warned :)

Things you will need for this mod:

TOOLS
Hot air gun & flux
Solder Wick
Soldering Iron (with fine tip & chisel tip)
Fine Tweezers
60/40 Solder 0.5mm is what I use

COMPONENTS
BGA7127 RF AMP IC
1.8 Ohms 0.1W, Resistor 0603 (could be smaller size but same power rating)
12 pF, Capacitor 0402
10 nF, Capacitor 0402
O Ohm, Resistor 0402 (or just a solder blob/wire shunt)

VIDEO TIMECODES:

Teardown: https://youtu.be/gPjJoWXVn-s?t=188
RF section: https://youtu.be/gPjJoWXVn-s?t=677
Desolder Initial parts: https://youtu.be/gPjJoWXVn-s?t=962
Installing new parts: https://youtu.be/gPjJoWXVn-s?t=1289
Soldering the new BGA7127 RF AMP IC: https://youtu.be/gPjJoWXVn-s?t=1637
Connecting 5v wire: https://youtu.be/gPjJoWXVn-s?t=1830
Removing the RF attenuator circuit: https://youtu.be/gPjJoWXVn-s?t=2089
Some RF power measurements: https://youtu.be/gPjJoWXVn-s?t=2310
Solder the metal can over rf section: https://youtu.be/gPjJoWXVn-s?t=2404
Connect the rf amp to 5v reg on the PCB: https://youtu.be/gPjJoWXVn-s?t=2404
Recap with schematic: https://youtu.be/gPjJoWXVn-s?t=2486
Closing the remote & finishing touches: https://youtu.be/gPjJoWXVn-s?t=2666

#TeamBlacksheep #Tango2 #500mWmod
Posted By

Livyu FPV

329     87    

Up Next

2:50
Out-of-Body Experience
2:48
RAW MAIDEN 🚀 KissFCv2, KISS 32a, GepRC Mark2, T-MOTOR F40PROv2
2:32
ROCKS /\ Don't Stop Flying !