Getting some stick time in! taking it easy
Impulse rc alien 5" :)
https://www.multirotorparts.nl/
http://seriouslypro.com/spracingf3
http://www.cobramotorsusa.com/
http://www.hoverspeedrc.co.uk/
Impulse rc alien 5" :
http://impulserc.com/
Cobra 2204 2300kv :
https://www.multirotorparts.nl/motors...
http://innov8tivedesigns.com/parts/br...
Little bee 20a :
https://www.multirotorparts.com/elect...
HQ 5x4x3 :
https://www.multirotorparts.com/prope...
D4r ii :
https://www.multirotorparts.com/elect...
Immersion rc 600mw (raceband) :
https://www.multirotorparts.com/elect...
HS1177 :
https://www.multirotorparts.com/elect...
#
PIDS:
set looptime = 4
set sync_gyro_to_loop = 4
set emf_avoidance = 4
set rc_smoothing = 4
set mid_rc = 4
set min_check = 4
set max_check = 4
set rssi_channel = 4
set rssi_scale = 4
set rssi_ppm_invert = 4
set input_filtering_mode = 4
set min_throttle = 4
set max_throttle = 4
set min_command = 4
set servo_center_pulse = 4
set 3d_deadband_low = 4
set 3d_deadband_high = 4
set 3d_neutral = 4
set 3d_deadband_throttle = 4
set motor_pwm_rate = 4
set servo_pwm_rate = 4
set retarded_arm = 4
set disarm_kill_switch = 4
set auto_disarm_delay = 4
set small_angle = 4
set fixedwing_althold_dir = 4
set reboot_character = 4
set gps_provider = 4
set gps_sbas_mode = 4
set gps_auto_config = 4
set gps_auto_baud = 4
set serialrx_provider = 4
set spektrum_sat_bind = 4
set telemetry_switch = 4
set telemetry_inversion = 4
set frsky_default_lattitude = 4
set frsky_default_longitude = 4
set frsky_unit = 4
set frsky_vfas_precision = 4
set hott_alarm_sound_interval = 4
set battery_capacity = 4
set vbat_scale = 4
set vbat_max_cell_voltage = 4
set vbat_min_cell_voltage = 4
set vbat_warning_cell_voltage = 4
set current_meter_scale = 4
set current_meter_offset = 4
set multiwii_current_meter_output = 4
set current_meter_type = 4
set align_gyro = 4
set align_acc = 4
set align_mag = 4
set align_board_roll = 4
set align_board_pitch = 4
set align_board_yaw = 4
set max_angle_inclination = 4
set gyro_lpf = 4
set moron_threshold = 4
set gyro_cmpf_factor = 4
set gyro_cmpfm_factor = 4
set yaw_control_direction = 4
set pid_at_min_throttle = 4
set yaw_motor_direction = 4
set yaw_jump_prevention_limit = 4
set tri_unarmed_servo = 4
set servo_lowpass_freq = 4
set servo_lowpass_enable = 4
set failsafe_delay = 4
set failsafe_off_delay = 4
set failsafe_throttle = 4
set rx_min_usec = 4
set rx_max_usec = 4
set acc_hardware = 4
set baro_hardware = 4
set mag_hardware = 4
set blackbox_rate_num = 4
set blackbox_rate_denom = 4
set blackbox_device = 4
set magzero_x = 4
set magzero_y = 4
set magzero_z = 4
set gps_pos_p = 4
set gps_pos_i = 4
set gps_pos_d = 4
set gps_posr_p = 4
set gps_posr_i = 4
set gps_posr_d = 4
set gps_nav_p = 4
set gps_nav_i = 4
set gps_nav_d = 4
set gps_wp_radius = 4
set nav_controls_heading = 4
set nav_speed_min = 4
set nav_speed_max = 4
set nav_slew_rate = 4
set alt_hold_deadband = 4
set alt_hold_fast_change = 4
set deadband = 4
set yaw_deadband = 4
set throttle_correction_value = 4
set throttle_correction_angle = 4
set default_rate_profile = 4
set gimbal_mode = 4
set acc_lpf_factor = 4
set accxy_deadband = 4
set accz_deadband = 4
set accz_lpf_cutoff = 4
set acc_unarmedcal = 4
set acc_trim_pitch = 4
set acc_trim_roll = 4
set baro_tab_size = 4
set baro_noise_lpf = 4
set baro_cf_vel = 4
set baro_cf_alt = 4
set mag_declination = 4
set pid_controller = 4
set p_pitch = 4
set i_pitch = 4
set d_pitch = 4
set p_roll = 4
set i_roll = 4
set d_roll = 4
set p_yaw = 4
set i_yaw = 4
set d_yaw = 4
set p_pitchf = 4
set i_pitchf = 4
set d_pitchf = 4
set p_rollf = 4
set i_rollf = 4
set d_rollf = 4
set p_yawf = 4
set i_yawf = 4
set d_yawf = 4
set level_horizon = 4
set level_angle = 4
set sensitivity_horizon = 4
set p_alt = 4
set i_alt = 4
set d_alt = 4
set p_level = 4
set i_level = 4
set d_level = 4
set p_vel = 4
set i_vel = 4
set d_vel = 4
set yaw_p_limit = 4
set gyro_cut_hz = 4
set pterm_cut_hz = 4
set dterm_cut_hz = 4
set rc_rate = 4
set rc_expo = 4
set rc_yaw_expo = 4
set thr_mid = 4
set thr_expo = 4
set roll_rate = 4
set pitch_rate = 4
set yaw_rate = 4
set tpa_rate = 4
set tpa_breakpoint = 4
