Low Filters is where it's at!!! - First Test RaceFlight Build 343

420 Views · Posted 7 years ago
I'm so excited for the future! This quad is flying like ABSOLUTE PURE BUTTER now!! The tune in this video is pretty dang close, but I just got done flying two more packs during my lunch break and tweaked it a little more and it's almost PERFECT :D

If you want to run the same tune here's what you gotta do. First, go watch Wild Willy's new video about Quopa Mode. Then, go download the newest version of RF1 (343 as of this writing), and follow Willy's instructions to a T, except set it to Low Filters instead of Normal (still change Yaw Gyro Averaging to 0).

Then, I slightly adjusted the PIDs trying to get rid of the slight, tight oscillations at higher throttle / overly twitchy feel when you are bashing on the sticks (...shouldn't be doing that, but I just can't help but aggressively throw that b-- around lol). On this video, I changed Roll P to 44, Pitch P to 42, and Yaw P to 40. It was pretty good, but felt a little less snappy / more delayed then I like. So over lunch I changed the PIDs back to Willy's (Skitzo's) except I raised Roll D to 34 and Pitch D to 33 and it's freaking AMAZINGLY GOOD!!! Sooooo much better than what you're about to see in this video I almost didn't upload it, but I'm not going to have time to edit the other one and upload yet today, so you get my first pack last night on Low Filters as well as a bit of footage from two packs I flew at sunrise this morning before it started raining again. Enjoy!!

Wild Willy's Video -
https://www.youtube.com/watch?v=3bJvTCJGByE

Download Newest RaceFlight Here
https://raceflight.com/quopa


Proudly Sponsored by AirVūz

*** Gear ***

~~Cinematic Drone~~
- DJI Inspire 2 - http://amzn.to/2qEtVQE
- DJI Zenmuse X4S - http://amzn.to/2sihFWY

~~5 Inch Build~~
- Armattan Chameleon - http://www.armattanquads.com/chameleon/
- RaceFlight Revolt V2
- RaceFlight Bolt 4-in-1 ESC
- EMAX RS2306 2750kv Motors
- HQ Props 5x4.8x3 V1S (**These Props are HEAVEN**)
- Runcam Swift 2 (camera tilt ~30°) - http://amzn.to/2si9hGS
- Lens from Runcam Swift RR Edition
- BMC3D TPU Chameleon GoPro Session Mount (30°) (This guy's stuff is seriously the best!!) - https://www.bmc3d.co/products/alien-3...
- Electret Mic with MAX9814 AGC Amp
- Lumenier AX II RP-SMA Antenna
- TBS Unify Pro V2 5v VTx (800mW) - http://amzn.to/2sii7EO
- FrSky XSR Receiver (SBUS) - http://amzn.to/2rYireJ
- Tattu R-Line 1550mAh 95C 4S LiPo

~~3 Inch Build~~
- Shendrones Shrieker 130
- KISS CC CompactCTRL
- BrotherHobby Tornado T1 1407 3600KV Motors
- XSOUL 3045 Bullnose Tri-Blade Props
- RunCam Split RC25G
- Lumenier AX II RP-SMA Antenna
- TBS Unify Pro V2 5v VTx (800mW) - http://amzn.to/2sii7EO
- FrSky XSR Receiver (SBUS) - http://amzn.to/2qF6Yws
- Tattu 850mAh 75C 4S LiPo

- GoPro Session5 - http://amzn.to/2qKBXGM
- GoPro Session5 Glass Stick-on Lens Protector - http://amzn.to/2roRfCM
- SanDisk Extreme 64GB microSDXC UHS-3 Card - http://amzn.to/2qKaswW

- FrSky Taranis X9D Radio - http://amzn.to/2sireFn
- FrSky M9 Hall Effect Gimbals - http://amzn.to/2rYG32y

- Fatshark Dominator HD3 - http://amzn.to/2ruvpjp
- LaForge V2 Main and Diversity Modules - http://amzn.to/2qFdMKo
- VAS Mad Mushroom - http://amzn.to/2sixWvi
- IRC 8dbi Patch - http://amzn.to/2rurnrc
- BMC3D TPU LaForge Covers - https://www.bmc3d.co/products/laforge...

*** Music ***
Skrillex & Diplo - Mind (feat. Kai) [BASECAMP & Mark Johns Remix]
https://soundcloud.com/jacku/mind-feat-kai-basecamp-mark
Posted By

KittFPV

464     92    

Up Next

4:39
Ovaflo'd my Mind with Ideas
4:28
It's that time of year AGAIN!!! - FPV Drone Semi Chasing
12:08
Adventuring with Kitt!! - VLOG #2