HIGH END RACING DRONE BUILD - Part 4 | Skull N Drones Rampage w/ Furiuos FPV Kombini

8,699 Views · Posted 8 years ago

This video documents how to build a racing drone with high-end parts like: Furious FPV Kombini flight controller and OSD/vTx board; Skull n' Drones Rampage quadcopter frame; ZTW Flash BLHeli_S ESCs; RunCam Eagle 4:3 camera; and Emax "Red-bottom" RS2205/2300kv motors.

Special thanks to sponsors who provided this gear for test/review: Skull n' Drones, Quadrysteria, RunCam, Furious FPV, and Asiatees.

Over the course of four videos and nearly an hour of total content, this playlist will show you all the steps of the build, from start to finish. Since the Kombini has a built-in PDB, there is a special focus on soldering in this build, including close-up views of good and bad solder joints. As always, I've scattered lots of helpful tips throughout.

Parts List:

Rampage frame - https://goo.gl/pGtHPm
Furious FPV Kombini - https://goo.gl/eEDs4I
Emax RS2205/2300kv CCW - https://goo.gl/ljeyrv
X4R-SB Receiver - https://goo.gl/ZDM2Lg
RunCam Eagle - https://goo.gl/8XHHs7
ZTW Flash 20A ESCs - https://goo.gl/oeDPKt

Video Tags

#racingdrone, #howtobuild, #build, #furiousfpv, #kombini, #flightcontroller, #quadcopter, #ztwflash, #blhelis, #runcameagle, #redbottom, #emax, #rs2205, #2300kv, #quadrysteria, #rampage, #skullndrones, #asiatees, #solder, #howtosolder, #badsolderjoints, #joshuabardwell, #soldering, #dronesrampagequadcopter, #racing, #drone, #expensive, #highend, #furious

Posted By