So I had tried to mount the FC / ESC stack in a different way on this rebuild. Since these RaceFlight boards have soft mount gummies and the Chameleon's deck is pretty low, mounting can be a little bit of a challenge. The way I had it mounted before was - M3 Bolt, O-Ring, Frame Bottom Plate, O-ring, O-ring (needed a little space between Frame and ESC), Bolt ESC, O-Ring, Revolt V2. Way too much softness lol. I had read that when using the Bolt and Revolt together you didn't really need to screw down the stack with nuts on the top, however, I think that only works well when you are using the direct pins instead of little jumper wires like I am. So here is the new mounting method - M3 Bolt, Frame Bottom Plate, Nylon Nut, Bolt ESC, Revolt V2, Nylon Nut. Seems to be A LOT better!! I might try going back to low filters instead of medium now and see how that works out :) Enjoy!!
Proudly Sponsored by AirVūz
*** Gear ***
~~Cinematic Drone~~
- DJI Inspire 2 -
http://amzn.to/2qEtVQE
- DJI Zenmuse X4S -
http://amzn.to/2sihFWY
~~5 Inch Build~~
- Armattan Chameleon -
http://www.armattanquads.com/chameleon/
- RaceFlight Revolt V2
- RaceFlight Bolt 4-in-1 ESC
- EMAX RS2306 2750kv Motors
- Lumenier 5x5x3 Butter Cutter Props (WildWilly)
- Runcam Swift 2 (camera tilt ~25°) -
http://amzn.to/2si9hGS
- Lens from Runcam Swift RR Edition
- Electret Mic with MAX9814 AGC Amp
- TBS Triumph CP Stubby RP-SMA Antenna -
http://amzn.to/2rJ5Wns
- TBS Unify Pro V2 5v VTx (800mW) -
http://amzn.to/2sii7EO
- FrSky XSR Receiver (SBUS) -
http://amzn.to/2rYireJ
~~3 Inch Build~~
- Shendrones Shrieker 130 -
http://amzn.to/2qEEYsY
- BrotherHobby Tornado T1 1407 3600KV Motors -
http://amzn.to/2qK7uZk
- DYS BLHeli XM 20A V2 ESCs (MultiShot)
- RMRC Seriously Dodo Flight Controller Rev 3b -
http://amzn.to/2sivEMI
- PowerOSD PDB (broken, gonna pull that out when I rebuild it next)
- XSOUL 3045 Bullnose Tri-Blade Props -
http://amzn.to/2rYdpP0
- 600TVL 110 Degree Wide Angle Super Mini FPV Camera
- TBS Triumph CP Stubby SMA Antenna -
http://amzn.to/2roJIUz
- UBAD 200mW VTx
- FrSky XSR Receiver (SBUS) -
http://amzn.to/2qF6Yws
- Tattu R-Line 1550mAh 95C 4S LiPo http://a.co/fGZACVM
- GoPro Session5 -
http://amzn.to/2qKBXGM
- GoPro Session5 Glass Stick-on Lens Protector -
http://amzn.to/2roRfCM
- SanDisk Extreme 64GB microSDXC UHS-3 Card -
http://amzn.to/2qKaswW
- BMC3D TPU Chameleon GoPro Session Mount (30°) (This guy's stuff is seriously the best!!) -
https://www.bmc3d.co/products/alien-3...
- FrSky Taranis X9D Radio -
http://amzn.to/2sireFn
- FrSky M9 Hall Effect Gimbals -
http://amzn.to/2rYG32y
- Fatshark Dominator HD3 -
http://amzn.to/2ruvpjp
- LaForge V2 Main and Diversity Modules -
http://amzn.to/2qFdMKo
- VAS Mad Mushroom -
http://amzn.to/2sixWvi
- IRC 8dbi Patch -
http://amzn.to/2rurnrc
- BMC3D TPU LaForge Covers -
https://www.bmc3d.co/products/laforge...
*** Music ***
Jane XØ - I Don't Wanna
https://soundcloud.com/janexomusic/i-dont-wanna-know-1
